Taylor L850 - Page 22

5-4
USER INTERFACE
Model L850, L852, L858 Series
User Interface
5
= X Key - Do not save current changes.
= Auto Calibrate Key - Indicates if the
grill has been calibrated.
= Star Key - Indicates the heaters are on
for the specific zone.
= Distributor Information Key - Displays
the contact information for the local
distributor.
= Brightness Key - Displays the current
brightness setting and allows the user to
change the brightness level.
= Store Information Key - Displays
general grill information and store
contact information.
= Histories Key - Displays clean, auto
level, events, alarms, and cycle count
history.
= Export Histories Key - Exports clean,
auto level, events, alarms, and cycle
count history.
= Gap Check Key - Moves the lower
platen to a defined gap.
= Main Key - Enters the main menu.
= Seconds Only Key - Allows the user to
change the countdown timer from
seconds only to minutes only.
= Display Key - Displays the Brightness
and Font Limit screens.
= Volume Key - Sets the desired volume.
= Language Key - Displays the available
languages.
= Configuration Key - Allows the user to
change the default settings.
= AM/PM Key - Allows the user to toggle
between AM and PM modes.
= General Key - Allows the user to
update software and inquire about and
update the configuration.
= Recipe Manager Key - Allows the user
to choose the grill mode (Manual/Auto)
and toggle between AM, PM, and
ALLDAY.
= Export Key - Allows the user to upload
recipes and other information from a
USB drive.
= Import Key - Allows the user to
download recipes and other information
from a USB drive.
= Copy From Key - Allows the user to
download recipes and other information
from a USB drive.
= Copy To Key - Allows the user to
upload recipes and other information
from a USB drive.
= Firmware Manager Key - Allows the
user to update software.
= Status Indicator Key - Allows the user
to see the overall health of the grill.
Future Development.
= Recovery Key - Allows the user to
enter the Recovery mode.
= Control Information Key - Displays the
part number and serial number of the
controls.
= Controls Key - Includes the Controls
Information key and the Control Status
key.
= Cycle Count Key - Allows the user to
enter the Life Cycle mode. Press the
Raise button to exit.