TC Electronic TC 2290 User Manual

have effect on the transmit channel, as the TC 2290 in this mode receives
on all channels.
The MIDI receive mode is set using SPEC.NO.5 which you can set to 'O' for
Omni On {receive on all channels), '! for Omni Off (recieve on selected
channel only).
(02) <ENABLE>
When the LED is lit, the TC 2290 responds to MIDI input messages. MIDI
inputs to the MIDI INPUT socket (on rear side) but always passes on to the
MIDI THRU socket (so you can have a MIDI chain of connections functioning
un-interrupted).
MORE ABOUT MIDI
Please refer to the seperate MIDI section <8.1> for more about MIDI with
the TC 2290.
5.12 THE EXTERNAL EFFECTS SECTION
With this section you are able to control the
on/off switching of up to 5 external effects
with the TC 2290. On the rear panel you will
find 5 sets of SEND/RETURN jack
connections. These sets are the ‘effect loop’
connections. The return no.5 is a stereo
RETURN set.
With the TC 2290 you can select which of the
five effects connected to the loop connections
should be part of the sound.
Each of the 100 presets can then store the
combination of effects you want, providing you
with a complete effects system with up to 100
preset sound combinations of DELAY, VOLUME
etc. settings and SUSTAIN, DISTORTION,
PHASER, EQUALIZER and STEREO CHORUS
and so on.
Every simple preset recall will then effect a
new sound setup.
For on-stage use the preset sound selection can be controlled from e.g. a
footpanel or via MIDI.
The EXTERNAL EFFECTS feature can be used to select up to 5 different
instruments by using the RETURN inputs only. Combinations like 2
instruments, 4 external effects are also possible.
If your combo amplifier has a remote effect on/off connection this can be
controlled as well.
In the studio this INPUT selection feature will typically be used to select
between different sources (channels) and/or to control 5 rackmount effects
which has a provision for external remote control.
(01) <CHANGE>
Pressing the <CHANGE> key enables numeric keyboard access (green LED
flashing) to control the external effects. With the green LED flashing,
pressing a number from <> to <5> will switch in or out the external effect
of this number.
Pressing <0> will switch in/out the total combination of the external
effects.
<> cancels ext. effects access.

TC Electronic TC 2290 Specifications

General

Brand	TC Electronic
Model	TC 2290
Category	Computer Hardware
Language	English