TC-Helicon Quintet User Manual

6
FRONT PANEL
POWER KEY
On/Off switch for the unit.
In order for altered SETUP and
current preset parameters to be
saved, the unit must be
powered off using this switch.
Powering down by removing AC
power will result in loss of
changes to these parameters.
LINE INPUT LEVEL KNOB
Adjusts the Line Input level.
Range: 24dB
INPUT METER
Peak meter shows Input level.
The Meter range is: 0 to -40dB.
INPUT CLIP LED
Indicates that the input level is
too high, possibly causing digital
distortion. Reduce the input
level to correct this condition.
OUTPUT CLIP LED
Indicates an internal DSP
overflow. Reduce the overall
level of the harmony voices and
vocal effects to correct this
condition.
MIDI IN LED
Indicates valid incoming MIDI
information.
LCD TEXT DISPLAY
Displays top-level preset
information (preset recall
mode), detailed preset
information (edit menus),
system configuration (setup
menu), and any important status
messages or user alerts.
VOICE KEYS (1-6)
On/Off function to set voicing.
These keys allow you to select
the voicing of the four harmony
voices. A maximum of 4 of these
keys may be enabled at a time.

TC-Helicon Quintet Specifications

Digital Output

frequency response DIO	DC to 22/23.9 kHz ± 0.01 dB @ 44.1/48 kHz
sample rates	44.1 kHz, 48 kHz
processing delay	0.1 ms

Analog Inputs

impedance balanced	3.6 kOhm
impedance unbalanced	1.8 kOhm
line input level @ 0 dBFS	24 dBu to 0 dBu

Analog Outputs

output impedance	40 Ohm
max. output level balanced	20 dBu
max. output level unbalanced	14 dBu

Operating Environment

operating temperature	32° F to 122° F (0° C to 50° C)
storage temperature	-22° F to 167° F (-30° C to 70° C)
humidity	Max. 90 % non-condensing

Supplementary

dimensions	19" x 1.75" x 8.2" (483 x 44 x 195 mm)
weight	4.1 lb. (1.85 kg)
mains voltage	100 to 240 VAC, 50 to 60 Hz (auto-select)