TC-Helicon Voicelive 2 Basic Manual

My corrected voice or harmony voice sounds
out of tune
It’s possible that the tuning reference of the instruments
you are singing with are not tuned to the default setting
of A=440. You can change the default tuning reference
in the I/O tab of the SETUP menu.
My sound is distorted.
Press and hold the REVERB footswitch and follow the
instructions for setting your mic gain.
If mic gain is set properly and the CLIP indicator is not
blinking, turn down the OUTPUT setting on the mix
screen or reduce the input level on your mixer channels.
I can’t hear any Reverb or Delay
1. Check the top level mix screen and make sure the
DELAY/REVERB level is turned up.
2. Confirm that the REVERB and/or DELAY footswitch
is turned on as indicated by its footswitch light.
3. Confirm that the send levels are up for the Reverb
and Delay block. To do this, press EDIT, navigate to
the REVERB or DELAY tab, and scroll down to the
Lead and Harmony send parameters and make sure
they are turned up.
4. If the send levels active are for the harmony voices,
make sure the Harmony effect is turned on.
I can’t hear any Harmony voices
1. Confirm that the Harmony effect is on by checking
the HARMONY footswitch.
2. Check the top level mix by turning one of the knobs
while on the home screen. Make sure the VOICES
level is turned up.
3. If the name of the preset has NOTES in it, it’s set
to MIDI NOTES or MIDI NOTES 4 CH and will
require you to play MIDI notes on the correct MIDI
channel to produce harmonies.
I don’t hear any audio from VoiceLive 2 when
using MIC in
1. Check that the DIGITAL IN parameter in the Setup
I/O tab is not set to USB VOX L / INST R or
DIGITAL VOX L / INST R.
2. Check to see if there is level in the INPUT meter
FAQ and Troubleshooting
36

TC-Helicon Voicelive 2 Specifications

Operating Environment

operating temperature	32° F to 122° F (0° C to 50° C)
storage temperature	-22° F to 167° F (-30° C to 70° C)
humidity	Max. 90 % non-condensing

Power

external power supply mains voltage	100 to 240 VAC, 50 to 60 Hz
power consumption	<14 W

Analog Inputs

mic input impedance	2.14/1.07 kOhm
line input impedance	13/6.5 kOhm
guitar input impedance	1 MOhm

Analog Outputs

output impedance	100/50 Ohm
output range	16 dBu / 0dBu
dynamic range	> 109 dB, 20 Hz to 20 kHz

Weight and Dimensions

dimensions	13.8" x 3" x 8.5" (350 x 76 x 216)
weight	5 lb. (2.3 kg)