Setup
VoiceLive 3 – Reference manual (2014-03-29) 99
CC Channel parameter
Use the CC Channel parameter to set the MIDI
Channel that VoiceLive3 “listens to” for incom-
ing MIDI Continuous Controller (CC) information.
The MIDI Channel and CC channel can be differ-
ent. This means that you can have VoiceLive 3
respond to Program Change information on one
channel and to CC information on another.
Transpose parameter
Use the Transpose parameter to shift incoming
MIDI note data up or down by up to 4 octaves.
If the output note after transposition falls outside
the available MIDI notes (i.e., if it is really high or
really low), the nearest octave note will be used
instead. For example, if you have set Transpose
to -4 octaves, but the note falls too far outside of
the acceptable MIDI note value range, the sys-
tem will try the next nearest transposition octave
of -3. If -3 is also too low, it will try -2 etc.
Split Note parameter
It is possible to define a specific area of your
MIDI keyboard for VoiceLive 3 to respond to.
Use the Split Note parameter to define a split
point. Use the Split Direction parameter to con-
trol whether notes above or below that note are
included.
Parameter settings: C-1 to G9
To Next Page
Loading...
Need help?
General
