TC-Helicon VoiceTone C1 User Manual

First Setup and Use
1.TurndownyourPA’smastervolume.
2.ConnectyourmicandPAasshowninthediagramfirst,thenplugintheACadaptor.Forlive
performance,aUSBconnectiontoacomputerisnotrequired.
3.SetthekeytoC,AttackcontroltoHardandtheGendercontroltothecenternotch.
Optional - Connect an instrument as shown to guide correction and override the Key selector.
4.SingintoyourmicwhileadjustingtheMICGAINcontrolsothattheinputlevelLEDflashesgreen.
BriefflashesofredontheLEDonyourloudestsingingareok.
5.Ensurethattheeffectison(centerLEDislit).
6.SingwhileturningupyourPAvolumetoacomfortablelevel.
Asyousing,youwillhearyourvoicejumpingfrompitchtopitchinthekeyofCmajor.Playan
instrumentoraccompanimentinthesamekeytoheartheHardTuneeffectincontext.Nowyoucan
experiment with the controls before reading the Effect Descriptions section below.
Phantom Power
ThereisnoswitchtoenablephantompowerontheVoiceTonesingles.Phantompowerisavailable
when the product is powered. Microphones that don’t require phantom power will operate properly.
AlwaysapplypowerasthelastconnectionstepandensureyourPAismuted.Thiswillreducethe
chance of audio pops that could harm your equipment.

TC-Helicon VoiceTone C1 Specifications

Input Specifications

mic input impedance	2.68 kOhm
mic input level at 0 dBFS	-42 dBu to +1 dBu
mic input EIN at max mic gain Rg = 150 Ohm	-126 dBu
mic input SNR	>104 dB
guitar input impedance	1 MOhm
guitar input level at 0 dBFS	-7 dBU to 17 dBu
guitar input SNR	>115 dB

Output Specifications

output impedance, balanced/unbalanced	200/100 Ohm
output full scale	+1 dBu
dynamic range	>104 dB, 20 Hz to 20 kHz
frequency response	+0/-0.3 dB, 20 Hz to 20 kHz

Power

power supply (supplied)	12V 0.4A
power consumption	5.6W

Operating Environment

operating temperature	32°F to 122°F (0°C to 50°C)
storage temperature	-22°F to 167°F (-30°C to 70°C)
humidity max.	90% non-condensing

Weight and Dimensions

dimensions	5.4” x 3.5” x 2.3” (140 x 90 x 60)
weight	0.92 lb. (420 g)