7 8
1.2 Getting started
Setting up
Inserting or removing the SIM/microSD
TM
card
1
Use the provided SIM pin to open the SIM tray.
2
Pull out the SIM tray.
3
Place the SIM card and/or microSD
TM
card into the tray slot and carefully close
the SIM tray.
You must insert your SIM card to make phone calls. You do not need to power off
your phone before inserting or removing the SIM card as this phone supports hot
swap.
MicroSD
TM
cards are sold separately. Your phone only supports Nano SIM
cards; attempting to insert other SIM types may cause damage to your
phone.
Charging the battery
Your new phone is partially charged. Charge the battery by using the USB-C cable
and charger provided. You are advised to fully charge the battery ( ). Charging
status is indicated by a percentage displayed on screen while the phone is powered
off. The percentage increases as the phone is charged.
To reduce power consumption and energy waste when the battery is fully
charged, disconnect your charger from the plug; switch off Wi-Fi, GPS,
Bluetooth or background-running applications when not in use; reduce the
backlight time, etc.
Reverse Charging with an OTG Cable
On-The-Go (OTG) is a USB transmitting technology that allows a phone to connect
to an external device with the help of an OTG cable.
You can use your phone to charge other devices using an OTG cable.
1. Connect your phone with the device to be charged using an OTG cable.
2. After connecting, a reminder box will pop up indicating that your phone can charge
the other phone and that the battery will reduce quickly during the charging.
3. Swipe down from the status bar to open the notification panel; tap Charging
connected device via USB, and then check that Supply power is selected by
default.
To Next Page
Loading...
Need help?
General
