49 50
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna�
Increase the separation between the equipment and receiver�
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected�
Consult the dealer or an experienced radio or television technician for help�
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Electronic labeling path: Touch Settings > About phone > E-Label or press *#07#, you can find more
information about labeling
(1)
, such as FCC ID.
Important Note
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
End users must follow the specific operating instructions for satisfying RF exposure compliance.
To maintain compliance with FCC RF exposure compliance requirements, please follow operation
instruction as documented in this manual.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter, except the transmitters built-in with the device.
(1)
This may vary depending on country.
US Information Concerning the Federal Communications Commission (“FCC”)
Requirements for Hearing Aid Compatibility with Wireless Devices
When wireless devices are used near hearing devices (such as hearing aids and cochlear implants),
users may detect a buzzing, humming, or whining noise. Some hearing devices are more immune
than others to this interference, and wireless devices also vary in the amount of interference that
they generate.
The wireless telephone industry has developed ratings to assist hearing device users in finding wireless
devices that may be compatible with their hearing devices. Not all wireless devices have been rated.
Wireless devices that are rated will have the rating displayed on the box together with other relevant
approval markings.
The ratings are not guarantees. Results will vary depending on the user’s hearing device and hearing
loss. If your hearing device is vulnerable to interference, you may not be able to use a rated wireless
device successfully. Consulting with your hearing health professional and testing the wireless device
with your hearing device is the best way to evaluate it for your personal needs.
This phone has been tested and rated for use with hearing aids for some of the wireless technologies
that the phone uses. However, other wireless technologies may be used in this phone that have not been
tested for use with hearing aids. It is important to try the different features of your phone thoroughly
and in different locations to determine if you hear any interfering noise when using this phone with your
hearing aid or cochlear implant. Consult your wireless service provider about its return and exchange
policies, and for information about hearing aid compatibility.
Hearing aid compatibility rating for this phone: M4/T4
How the ratings work
M-Ratings: Wireless devices rated M3 or M4 meet FCC requirements and are likely to generate less
interference to hearing devices than wireless devices that are not labeled. M4 is the better or higher
of the two ratings.
T-Ratings: Wireless devices rated T3 or T4 meet FCC requirements and are likely to be more usable
with a hearing device’s telecoil (“T Switch” or “Telephone Switch”) than unrated wireless devices. T4
is the better or higher of the two ratings. (Note that not all hearing devices have telecoils in them.)
Hearing devices may also be measured for immunity to this type of interference. Your hearing device
manufacturer or hearing health professional may help you find results for your hearing device. The
more immune your hearing aid is, the less likely you are to experience interference noise from wireless
devices.
For more information about the actions that the FCC has taken with regard to hearing aid compatibility
with wireless devices and other steps that the FCC has taken to ensure that individuals with disabilities
have access to telecommunications services, visit www.fcc.gov/cgb/dro.
To Next Page
Loading...
Need help?
General
