TCL HH130VM - Connect in WPS Mode

12
Getting started with your device
3) Whenpromptedforapassword,entertheWi-Fipasswordfoundonthedevicelabel(this
iscasesensive).Yourclientwillnofyyouwhenitisconnected.
y
SetupaWi-FiconneconthroughWPS.Fordetails,see“3.4.2ConnectinWPSmode”.
3.4.2 
YourclientmustsupportWPS.Thereare3waystosetupaWPSconnecon.

WPSbuon
1) PressandholdtheWPSbuonfor3seconds.TheWi-Fiindicatorwillbegintoashblue.
2) EnableWPSonyourpersonaldevicewithin2minutes.
3) Yourpersonaldeviceshouldthenbeconnectedtoyourdevicewirelessly.

via

buoninWebUI
1) OpentheWPSpageonyourWebUI.
2) Go to

>

>

3) Clickon

.
4) EnableWPSonyourpersonaldevicewithin2minutes.
5) Yourpersonaldeviceshouldthenbeconnectedtoyourdevicewirelessly.

WPSPINcode
1) OpentheWPSpageonyourWebUI.
2) Go to

>

>

.
3) Switchon
Router's PIN
.
4) EnterthePINcodeonyourpersonaldevice.