-
-
-
-
-
-
Kg
mm
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
OPERATING TEMPERATURE
OPERATING HUMIDITY
STORAGE TEMPERATURE
STORAGE HUMIDITY
VIBRATION (*9)
SHOCK
WEIGHT
SIZE (WxHxD)
OUTPUT ON/OFF
OUTPUT GOOD
OUTPUT VOLTAGE PROGR.
OUTPUT CURRENT PROGR.
REMOTE SENSING
COMMUNICATION INTERFACE
ENVIRON-
MENT
MECHANI-
CAL
EXTERNAL
FUNCTIONS
SAFETY STANDARDS
EMC STANDARDS
APPRO-
VALS
NOTES:
* 1 MINIMUM VOLTAGE IS GUARANTEED TO MAXIMUM 0.2% OF
THE RATED OUTPUT VOLTAGE.
* 2 MINIMUM CURRENT IS GUARANTEED TO MAXIMUM 0.4% OF
THE RATED OUTPUT CURRENT.
* 3 GIVEN FOR CONTROL
OF THE OUTPUT VIA THE SERIAL COMMUNICATION OR VIA FRONT PANEL CONTROLS.
* 4 TIME FOR RECOVERY TO WITHIN +/- 50mV AGAINST CURRENT CHANGE OF 50% TO 100%.
* 5 INVERTER SHUT DOWN METHOD, MANUAL
RESET BY AC INPUT RECYCLING.(OVP WILL SHUT DOWN OUTPUT).
* 6 AT 100V/200V AND MAXIMUM OUTPUT
POWER.
* 7 FOR 200W UNITS -
AT COLD START Ta = 25°C.
* 8 FOR CASES WHERE CONFORMANCE
TO VARIOUS SAFETY SPECS, (UL, IEC ETC.)
ARE REQUIRED TO BE DESCRIBED
AS 100-240VAC (50/60Hz) ON NAME PLA
TE.
* 9 WHEN MOUNTED WITH MOUNTING SCREWS.
*10 FROM NO LOAD TO FULL LOAD , CONSTANT INPUT VOLTAGE AT REMOTE SENSE.
*11 FROM 85~132VAC OR 170~265VAC , CONSTANT LOAD.
*12 FROM ZERO VOL
TS TO FULL SCALE , RESISTIVE LOAD , CURRENT
SETTING AT MAX.
CONDUCTED EMI
RADIATED EMI
SERIAL OPERATION
PARALLEL OPERATION
COOLING
ISOLATION RESISTANCE
WITHSTAND VOLTAGE
ZUP60-
7
3.2
3.2
3.2
ZUP60-
3.5
2.9
2.9
2.9
ZUP36-
12
ZUP36-
6
ZUP20-
20
ZUP20-
10
ZUP10-
40
ZUP10-
20
ZUP6-
66
0 ~ 50 C: 100% Load.
O
-20 ~ 70 C
O
30 ~ 90% RH ( No Dewdrop )
10 ~ 95% RH ( No Dewdrop )
Less than 20G
10 ~ 55Hz, Amplitude (sweep 1min) Less than 2G
, X,Y, Z, 1 hour each.
70 x 124 x 350.
By TTL Signal or Dry Contact - refer to instruction manual
Open collector - refer to instruction manual
By Voltage ( 0 ~ 4V ) or by Resist
ance ( 0 ~ 4K ) refer to instruction manual
By Voltage ( 0 ~ 4V ) or by Resist
ance ( 0 ~ 4K ) refer to instruction manual
Maximum possible drop on each load wire is 0.5 V for models up to 60V and 2V for the 80V and 120V models.
RS232 and RS485 Built-in, IEEE488 Optional
UL 3111-1, EN61010-1
EN 61326-1, IEC 61326 -1, FCC p
art 15 (class A)
Master - slave method: up to 5 unit
s, refer to instruction manual
Up to 2 units, refer to instruction manual
EN55022-B, FCC-B, VCCI-B
Forced air by blower fan, (blower fan is mounted within unit)
EN55022-A, FCC-A, VCCI-A
Input-Chassis: 2.0kVAC 1 min. Input-Output: 3.0kV
AC 1 min. Output-Chassis:
500V
AC 1min.
Input-Chassis: 2.0kVAC 1 min..
Input-output(HAZ
) : 2.0kV
AC 1min.
Input-Output(SELV):3.0kVAC 1min.
ZUP6-
33
3.2
3.2 2.9
2.9
3.2
3.2 2.9
2.9
2.1 SPECIFICATIONS: 200W/400W Series continued
ZUP120-
3.6
ZUP120-
1.8
ZUP80-
5
ZUP80-
2.5
More than 100MOhm at 25
C and 70% R.H.
O
To Next Page
Loading...
