Need help?Do you have a question about the TDK-Lambda GENESYS 750W HALF RACK and is the answer not in the manual?
Specifies voltage, current, and power ratings for different models.
Details input voltage, current, power factor, and efficiency.
Details foldback, over-voltage, and under-voltage protection features.
Lists applicable safety and EMC standards and withstand voltages.
Steps for preparing the power supply for operation, including AC source.
Instructions for installing the power supply in a standard 19" rack.
Specifies the required AC input voltage and frequency range.
Details how to safely connect the power supply to the AC source.
Step-by-step guide for verifying power supply operation after connection.
Guidance on selecting wiring and making load connections to the power supply.
Explains how to configure and use local and remote sensing for voltage regulation.
Detailed explanation of front panel buttons, knobs, and displays.
Describes rear panel connectors, switches, and terminals.
Details the OVP circuit, its function, and setting procedures.
Explains the UVL function for setting output voltage limits.
Describes foldback protection for overcurrent conditions.
How to program voltage and current using remote analog signals.
How to program voltage and current using external resistors.
Overview of commands, categories, and arguments for serial control.
Guide to diagnose and resolve operating problems using symptoms and checks.
General| Output Power | 750 W |
|---|---|
| Form Factor | Half Rack |
| Output Current | 0-12.5 A |
| Output Voltage | 0-60V (depending on model) |
| Control Interface | Analog |
| Operating Temperature | 0 to +50 °C |
| Protections | Over Voltage, Over Current, Over Temperature |
To Next Page