Need help?Do you have a question about the TDK-Lambda Genesys GEN 3300W and is the answer not in the manual?
Details electrical and network configuration specifications for the LAN option.
Describes the function and operation of the LAN enable DIP switch.
Explains the three IP address assignment modes: DHCP, Auto-IP, and Static IP.
Details the procedure for changing the IP address via the front panel controls.
Explains how to reset the LAN settings to the factory default configuration.
Describes the output control interface for setting voltage and current limits.
Details how to modify output settings like voltage and current via the web interface.
Explains how to configure protection settings like OVP, UVL, and foldback.
Describes the main LAN configuration settings available on the web page.
Details how to modify LAN settings such as IP address, subnet mask, and hostname.
Details SCPI command syntax rules including terminators, abbreviations, and spaces.
Explains how to set the voltage limit using the SCPI command.
Explains how to set the current limit using the SCPI command.
Explains how to control the power supply output state via SCPI commands.
Explains how to measure the output voltage using the SCPI query.
Explains how to measure the output current using the SCPI query.
Explains how to set local or remote operating modes using SCPI commands.
Explains how to set Over-Voltage Protection (OVP) levels via SCPI.
Explains how to read the Over-Voltage Protection trip status via SCPI.
Explains how to set the Under-Voltage Limit (UVL) via SCPI commands.
Explains how to enable or disable foldback protection via SCPI.
Explains how to read the foldback protection trip status via SCPI.
Explains the SCPI command to reset all LAN settings to factory defaults.
Explains the *RST command to reset the power supply to a safe state.
Explains how to read system errors from the queue using SYSTEM:ERROR? query.
Explains the *CLS command to clear status and error registers.
Explains setting up the master LAN supply for multi-drop operation.
Details the steps required to set up the master supply for multi-drop.
Explains setting the unique RS-485 address for each supply in a multi-drop chain.
Details connecting and configuring the RS-485 slave supplies.
Details the steps for setting up an RS-485 chain with slave supplies.
Explains selecting a single supply for commands using INST:SEL in a chain.
Explains global commands that affect all supplies in a multi-drop chain.
Explains selecting a specific supply using the INST:SEL command.
Explains the global command to set the voltage limit on all supplies simultaneously.
Explains the global command to set the current limit on all supplies simultaneously.
Explains the global command to control output state for all supplies.
Explains the global command to reset all power supplies in the chain.
Explains the global command to save settings for all power supplies.
Explains the global command to recall settings for all power supplies.
Troubleshooting steps for missing IP address and a red LAN status LED.
Troubleshooting steps for zero IP address and a red LAN status LED.
Troubleshooting steps for communication issues after verifying IP address.
Troubleshooting steps when the refresh list fails to detect slave supplies.
General| Output Power | 3300 W |
|---|---|
| Cooling | Forced air |
| Input Frequency | 47-63 Hz |
| Efficiency | 93% |
| Programming | Analog, RS-232, RS-485, USB, LAN |
| Operating Temperature | 0 to +50°C |
| Protections | Over voltage, over current, over temperature |
| Output Voltage Range | 0-600V |
| Output Current Range | 0-55A |
To Next Page