TDW PIG-SIG V - Extension Installation

54
Section V – Indicator Installation
1.0 Continued
E. Push the flag down until it locks in the horizontal
position (Figure 5.5). The PIG-SIG V is ready for
operation.
Follow these instructions for installation of all
indicator types (Figure 5.6 and 5.7).
Figure 5.5 Flag In
Horizontal Position
Figure 5.6.Electrical-
Only Indicator
Figure 5.7.
Flag/Electrical
Combination Indicator
1.2 Extension Installation
If the indicator is installed on a 1 to 10 foot extension,
it is installed exactly the same as the indicator itself
(Figure 5.8).
A. If using an indicator on an extension, position the
strip of EPDM rubber gasket (provided) over the
three set screws (Figure 5.9).
B. Before burial, secure the rubber gasket with the
316 stainless-steel hose clamp (provided).
Figure 5.8. Extension
Figure 5.9. Secure Extension Base