Teac AG-V4200 - Troubleshooting; Power; Amplifier; Tuner

TROUBLESHOOTING
To
determine
any
problem
with
your
receiver,
always
check
the
most
obvious
possible
causes
first.
If
any
problem
still
remains
after
you
have
checked
the
items
below,
consult
your
nearest
TEAC
dealer.
Problem
Probable Cause
Power _
No power
Power cord is not plugged in.
Plug in the power cord securely.
Power does not come on even when
the POWER button on the remote
control unit is pressed.
The POWER button on the front
panel is OFF.
Press the POWER button on the
front panel to ON.
Amplifier -
Sound cannot be heard.
The MUTING button is set to ON.
Be sure to set the MASTER
VOLUME control to minimum, then
set the MUTING button to OFF.
The TAPE MONITOR button is ON.
Set the TAPE MONITOR button to
OFF.
Sound is only heard from one
channel.
The BALANCE control is set to one
| end.
Adjust the BALANCE control.
One of the input cords is
disconnected.
fe
Connect the input cords securely.
Low-frequencies are insufficient and
the image of mid-frequencies is not
fixed.
The plus and minus connections of
either of the front speakers are
reversed.
Connect the speakers with the
correct polarities.
Hum or noise.
Audio equipment is too near the TV.
Move the TV away from the audio
equipment.
No tuning.
The antenna is not connected.
Connect the antenna.
Auto tuning not possible.
Signal strength of the stations is too
weak.
Perform manual tuning.
Use a better external antenna and
adjust its direction.
STEREO indicator fails to light
during stereo broadcasts.
FM MODE button is set to Mono
mode.
Set the FM MODE button to Stereo
mode.
Electromagnetic interference.
Ignition noise from cars.
Use the external antenna and install
it away from the street.
TV too near the receiver.
23
Move the receiver away from the
TV.