Teac BX-330 - 2 VOLTAGE CONVERSION; 2-1 Voltage Conversion Procedure

— Phono MM Section —
SOURCE
Selector:
PHONO-MM,
VOLUME
Control:
MIN
input Level
input:
1
kHz/2.5
mV
(Signal
source
impedance:
3.32)
REC
QUT:
150
mV
+3
dB
Frequency Response
+19 dB +1dB
+13.1 dB +0.5 dB
0 dB (reference)
-13.7 dB +0.5 dB
~19.6 dB +1 dB
20 Hz:
100 Hz:
1 kHz:
10 kHz:
20 kHz:
Harmonic Distortion
Output: 7V
20 Hz: Less than 0.01%
1kHz: Less than 0.005%
20 kHz: Less than 0.1%
Noise Level
Input: 3.30 terminate
Less
than
48
xV
(approx.
-86
dB),
Weighted
BX-550/8X-330
— Phono MC Section —— ;
SOURCE Selector: PHONO MC, VOLUME Control: MIN
Input Level
Input: 1kHz/50 pV (Signal source impedance: 3.32)
REC OUT: 150 mV +3 dB
Frequency Response
20Hz: +19dB+1dB
1 kHz: 0O4dB (reference)
20 kHz: -19dB+1dB
Harmonic Distortion
REC OUT: 1V
20 Hz: Less than 0.1%
1kHz: Less than 0.1%
20 kHz: Less than 0.7%
Noise Level
Input: 3.320 terminate
Less than 250 uV (approx. -72 dB), Weighted
2 VOLTAGE CONVERSION
VOLTAGE
CONVERSION
(GENERAL
EXPORT
MODEL
ONLY)
BE
SURE
TO
REMOVE
THE
POWER
CORD FROM
THE
AC
OUTLET
BEFORE
REMOVING
THE
OUTER
CASE
AND
RE-
POSITIONING
THE
VOLTAGE
CONVERSION
PLUG.
1.
2.
Remove
the
top
and
side
metal
cover
unit
by
removing
the
screws
from
each
side.
Locate
the
voltage
selector
plug
on
the
left
side
of
the
BX-550/
BX-330.
Remove
the
plug
by
pulling
it
out,
then
re-insert
it
so
that
the
arrow
on
the
plug
exactly
fines
up
with
the
white
line
that
in-
dicates
the
appropriate
voltage.
. Replace the cover.
Fig. 1