Teac FD-55 Series - 230

(a) Installation
Install a short bar securely to short the two pins lleft and right
in parallel) in Fig.208. There is no restriction for the approach of
the short bar insertion. However, for the easy visual checking of the
on-state, it is recommended to insert the metal bar at the upper side
of the post pins.
(b) Removal
To
protect from unwanted removal due to vibration and impact, the
short bars are very securely inserted. If it is not removed when
nipped up with fingers, pull up slowly with a small round nose pliers.
Be careful not to damage the parts around it.
(2) Ordering of short bars
If more short bars than the standard installation at shipping are required,
or if short bars as spare parts are required, order with the following
parts number.
Short bar TEAC P/N : 13121149
Maker P/N : Honda Tsushin Kogyo Co., Ltd. DIC-S252
(3) HS ~ MX strap block
(a) MX strap
The on-state of this strap is used when only one FDO is connected
to the system. All the input/output signals are valid in this
condition independent of the DRIVE SELECT signal.
The off-state of this strap is used when multiple FODs (4 FODs, Max.)
are daisy chained or when input/output signals are enabled by the
DRIVE SELECT input signal for only one FOD connected. It is necessary
to set the MX strap off of any daisy chained FDD in a multiple
- 230 -