ENGLISH
17
Specifications
TUNER Section
Frequency Range(FM):
87.50 MHz to 108.00 MHz
Frequency Range(AM):
520 kHz to 1,710 kHz
CD PLAYER Section
Frequency Response:
20 Hz to 20 kHz(±1dB)
Wow and Flutter:
Unmeasurable
SPEAKER SYSTEM Section
Type:
65 mm x 2
Impedance:
4 ohms
GENERAL
Total Output Power:
3 W + 3 W
Power Requirement:
120 V, 60 Hz
Power Consumption:
25 W
Dimension ( W x H x D ):
14.2" x 5.1" x 9.9" (361 x 129 x 251 mm)
Weight:
7.8 lbs (3.6 kg)
Standard Accessories:
Owner’s Manual x 1
Warranty Card x 1
< Design and specifications are subject to change
without notice.
< Illustrations may differ slightly from production
models.
Troubleshooting
If you have problems with your system, look through
this chart and see if you can solve the problem
yourself before calling your dealer or TEAC service
center.
General
No power
e Check the connection to the AC power supply.
No sound.
e Adjust the volume.
e If muting is on, press the MUTING button.
The sound is noisy.
e The unit is too close to a TV set or similar
appliances. Install the unit further from them, or
turn them off.
Tuner
Cannot listen to any station, or signal is too
weak.
e Tune in the station properly.
e If a TV is near the unit, turn it off.
e Rotate the unit or antenna wire for the best
reception position.
CD Player
Cannot play.
e Load a disc with label side facing you.
e If the disc is dirty, clean the surface of the disc.
e Don’t use scratched, damaged or warped discs.
e Depending on the quality of the disc and/or the
condition of the recording, some CD-R/CD-RW
discs may not be playable.
e Copy-protected discs may not be playable.
Sound skips.
e Place the unit on a stable place to avoid vibration
and shock.
e If the disc is dirty, clean the surface of the disc.
e Don’t use scratched, damaged or warped discs.
To Next Page
Loading...
