Teac SR-L50 - Programmed Playback: Setting Up; Programming Tracks; Starting Programmed Playback

15
ENGLISH
Within 10 seconds, press the MEMORY/CLOCK ADJ
button.
The track is programmed, and “P-02” is displayed.
Repeat steps and to program more tracks.
<
You can program up to 20 tracks.
<
You can also use the front panel buttons to select a
track number. In this case, press the SKIP/SEARCH
button to select a track number and then press the
MEMORY/CLOCK ADJ button while “MEMORY” is
blinking on the display.
<
To cancel the program mode, press the STOP button
(H
).
When the selection of track numbers is completed,
press the PLAY/PAUSE button (y
/J ) to start
program playback.
If the PLAY/PAUSE button (y/J) isn’t pressed
within 10 seconds, the MEMORY indicator will go
off. In that case, press the MEMORY/CLOCK ADJ
button and then press the PLAY/PAUSE button
(y
/J) to start program playback.
The programmed contents are kept in memory even
after the FUNCTION button is pressed or the power
is turned off.
4
32
3
Up to 20 tracks can be programmed in the desired
order.
<
Shuffle playback does not work during program
playback.
<
Insert a disc and select “CD” before beginning
programming.
Press the MEMORY/CLOCK ADJ button in the stop
mode.
“MEMORY” indicator blinks, and “P-01” appears on
the display.
Within 10 seconds, press the numeric buttons to
select a track.
Example 1:
To select the track No.5:
Example 2:
To select the track No.23:
<
If the numeric buttons aren’t pressed within 10
seconds, program mode will be canceled.
2
1
Programmed Playback (1)
2
4
1 3