● USB mode - Set which mode to use when
USB-C cable is connected
Continuation of radio setup
● Rx channel order - Determines the order
in which the four primary controls
(Rudder, Elevator, Aileron, and Throttle)
are inserted on channels 1-4 when
creating a new model
● Mode - Determines which sticks move
which controls on the airplane
This is the place where switches can be used to trigger
special functions such as soundtrack playback, speech
output of variables etc.
● Global functions are special functions that are
applied across all planes.
Configure all the installed input sticks, switches and
buttons
● Sticks - Perform the calibration of the
hall-effect magnetic gimbals
● Switches - Sets the type of switches
To Next Page
