For those familiar with the TBS CROSSFIRE LUA script
on OpenTX, this is the same menu.
CROSSFIRE configuration for TANGO II
● Set failsafe - Set a stick position on signal
loss. Only if fs type is set to POS
● Bind - Initialize the CROSSFIRE receiver
binding procedure
● General - Operating parameters
○ Region - Select your region to set the
right frequency band and power
○ Max. power - Manually adjust the
max. RF power output
○ Dynamic power - Automatically adjust
RF power output in accordance to
received signal indicators
○ Frequency - Frequency band to use,
868MHz (Europe, Russia) or 915MHz
(USA, Asia, Australia)
○ Operation mode - Normal
(recommended) or Forced telemetry
To Next Page
Loading...
