Attention
These Long Range Systems are capable to use radio frequency transmissions and output power that may
be not allowed in your country. The radio will arrive locked to your country’s regulations!
Please always check your local RF legislation to set the frequency and output power according with
the regulation.
A general rule for RC aircrafts is that they must be controlled always under sight of view, check your RC
regulation to keep up to date with regulations.
FAQ
● My Tango does not bind to the receiver - both are blinking slowly green
○ Update your build-in Crossfire to 3.73 (beta) or later and retry
● After binding, the receiver shows a double pattern and i get no signals in BF/ INAV/ …
○ This is an authentication error on the crossfire. To solve it:
■ Shut down your drone and the Tango
■ Power up the Tango
■ Set it in Bind-mode
■ Power up the receiver
■ Push the bind button on the receiver
After a few seconds the green led on the receiver should switch to a constant green light
● I get movements BF/ INAV/ … on the 4 sticks but not from any switch
○ You need to assign the switches in the “Mixer” page of you model to a channel you’d like it
to be. For detailed informations on the mixer page, have a look at Painless360’s opentx
video series
Manual written and designed by ivc.no in cooperation with TBS and Kamikatze-fpv.de.
To Previous Page
