Team Orion Vortex R8.1 pro - Adjustable Parameters; Running Mode

www.teamorion.com 13
ash = setting 1, two ashes = setting 2 and so on. Press
the button to switch between the dierent available
settings.
G. Press and hold the setup button for 3 seconds to save the
modication.
H. Power the ESC o and back on to make the parameter
change eective.
Note: you can only change one setting at a time, after each
modication you need to power the ESC o and back on to
make the parameter change eective and be able to modify
another parameter.
ADJUSTABLE PARAMETERS
1. Running Mode
You can enable or disable the reverse function. There are
also separate sensorless and sensor modes. The ESC drives
the motor dierently depending on wether the sensor or
sensorless mode is selected.
“Forward Only with Brake” this mode is meant for
competition use. In this mode the car can go forward and
brake, there is no reverse.
“Forward/Reverse with Brake” this is the basic all-around
mode. In this mode the car can go forward and reverse and
can also brake. When you move the throttle to the reverse
position while the car is moving forward, brakes are applied
until the car stops, reverse cannot engage while the car
is moving. To engage reverse, once the car has stopped,
release the brakes and move the throttle to the reverse
position again. While braking or in reverse, if the throttle