TEC MA-1350-1 Series - Discount and Charge Operations; Percent Discount and Charge; Dollar Discount Function

- 35 -
EO3-11084
MA-1350-1 SERIES
(Optional Functions 3)
0
▼
Initial SET Bit Nos.
Your Selection
▼
Supplementary Description for Address 12:
Bits 1, 2, 6, 8: SET status ........ When each key is operated, the SLIP lamp will flicker to prohibit all the
operations (including control lock position change and cashier key
change) other than the validation print. The status of this bit is
applicable in the REG or MGR position, and is not applicable in the
“ - ” position.
Bits 5, 7: RESET status... The key can operate in “REG” mode.
SET status ........ Operating the key in “REG” mode will cause an error. The Control Lock
must be turned to “MGR” position (or “ - ” position for reverse process).
1 Validation Compulsory for the [FS TL TEND] key
2 Validation Compulsory for the [TRF] key (New Balance)
3,4 -- vacant --
5 MGR Intervention Requirement for the [VND CPN] key
6 Validation Compulsory for the [VND CPN] key
7 MGR Intervention Requirement for the [STR CPN] key
8 Validation Compulsory for the [STR CPN] key
Content
Bit
No.
Selective Status
RESET
SET
NOT COMPULSORY
COMPULSORY
Address : 1 2
NOT COMPULSORY
COMPULSORY
NOT COMPULSORY
COMPULSORY
NOT REQUIRED
REQUIRED
NOT REQUIRED
REQUIRED
NOT COMPULSORY
COMPULSORY