TEC MA-1350-1 Series Programming Manual

- 82 -
EO3-11084
MA-1350-1 SERIES
NOTES: 1. The Decimal Point cannot be entered in the Register Number.
2. Preceding zeros, if any, will not be printed. For example, if “001234” is entered, “#1234”
will be printed.
Foreign Currency Exchange Rate Setting
Condition: Any time outside a sale
Programming Procedure:
CUR 1
Exchange Rate; max. 10 digits; 0.000001 to 9999.999999 NOTE 1,2
.
7
1
4
30
.
CUR 2
.
CUR 3
.
CUR 4
.
CUR 1
TEC STORE
1343 PEACH DRIVE
PHONE: 87-6437
Open 8:00am to 7:00pm
Closed: every Wednesday
11-28-1997 #112300
P00
CUR1 0.7143 *
0104 12:38TM
NOTES: 1. Obtain the rate by calculating in the subsidiary currency unit values for both the domestic
and the foreign currency. (In case of calculating the rete from the domestic to a foreign
currency with the same zero-suppress form, such as from US$ to Frency Franc, it will be
no problem. However, in case of exchanging from a domestic currency such as US$ to a
foreign currency such as Japanese yen, this rule must be obeyed; otherwise a wrong rate
will result.)
2. Calculate the required foreign currency value equivalent to the domestic currency value
“1”. Then the obtained value is the Exchange Rate value to be entered in the setting
operation above.
Example) Domestic Currency is US$:
1 cent = XXXX . XXXXXX centimes (French Franc)
= XXXX . XXXXXX pfennigs (Deutsche Mark)
= XXXX . XXXXXX yen (Japanese Yen)
etc.
Enter this value as the foreign currency exchange rate.
3. If “0” is set as the exchange rate, that key cannot be used in sale entries.
Example)
0.7143 for the [CUR 1] key:

TEC MA-1350-1 Series Specifications

General

Brand	TEC
Model	MA-1350-1 Series
Category	Cash Register
Language	English