- 60 -
EO3-11084
MA-1350-1 SERIES
Hourly Range Table Programming
Condition: After Hourly Sales Reset
Programming Procedure:
NOTES: 1. A maximum of 24 hourly ranges may be set.
2. Do not set an hourly range across 24:00, such as “from 23:00 to 1:00”. Such setting
does not cause an error in programming but the sales data will not be processed into
that hourly range.
3. If an hourly value of more than 23 or a minute value of more than 59 is set, it will not
result in an error but the data will not be processed into that hourly range.
4. To change the table of hourly ranges once set, partially or entirely, do the entire
setting operation over again.
5. To clear the hourly range table once set, operate in SET mode:
Repeat for setting next Hourly Ranges (max. 24 hourly ranges)
Enter the time that ends the
Hourly Range, in the 24-hour sys-
tem using the military time. (The
time to start is the time entered for
the preceding Hourly Range.)
(See NOTES 2, 3)
7
Declaration of Program
No. 7 for Hourly Range
Table programming
@/FOR
Hour Minute
(0 to 23) (00 to 59)
#/NS
AT/TL
7
@/FOR
0
#/NS
AT/TL
▼
To Next Page
Loading...
Need help?
General
