TEC MA-1350-1 Series - Item Correction and Voiding; Item Correction (Last Line Voiding); Designated Line Voiding

- 37 -
EO3-11084
MA-1350-1 SERIES
0
▼
Your Selection
▼
Supplementary Description for Address 13:
Bits 1 to 8: SET status ..... .. When each key is operated, the SLIP lamp will flicker to prohibit all the
operations (including control lock position change and cashier key
change) other than the validation print. However, Item Correct can be
performed to the item-correctable transactions. The status of this bit
is applicable in the REG or MGR position, and is not applicable in the
“ - ” position.
• All Void during the validation compulsory status can be performed.
Initial SET Bit Nos.
1 [RTN MDSE] key
2 [PO] key
3 [R/A] key
4 [ITEM CORR] key
5 [VOID] key
6 [DOLL DISC] key
7 [%-] key (% I, % II)
8 Negative Departments and Negative PLUs
Content
Bit
No.
Selective Status
RESET
SET
COMPULSORY
COMPULSORY
COMPULSORY
COMPULSORY
COMPULSORY
COMPULSORY
COMPULSORY
COMPULSORY
NOT COMPULSORY
NOT COMPULSORY
NOT COMPULSORY
NOT COMPULSORY
NOT COMPULSORY
NOT COMPULSORY
NOT COMPULSORY
NOT COMPULSORY
Address : 1 3
(Validation Compulsory 1)