To Next Page

To Previous Page

- 56 -

EO3-11084

MA-1350-1 SERIES

NOTES: 1. “Address No.” designation located after the key operation “4 [@/FOR]” can be omitted if

unnecessary. When an address No. (1, 2, 4 or 5) is designated, the programming of the

designated address will be automatically repeated for multiple PLUs.

2. Max. 500 PLUs are available when the RAM capacity is 32 KB.

Max. 1000 PLUs are available when the following two conditions have been satisfied.

• RAM capacity is 128KB.

• The program option “Expansion of the number of the PLUs” is selected.

(Refer to Address 23-Bit 1 of “System Option Setting” in this chapter.)

3. When sequentially programming the PLUs, the code specification can be omitted. When it

is omitted at the very first PLU, PLU Code “1” is automatically assigned.

4. The statuses (Positive/Negative Status, Tax Status, GST or Food Stamp Status and

Itemized/Single-item Status) of each PLU is decided by the statuses of the Department to

which the PLU is linked.

5. If a PLU is linked to an Other Income Department, entering the PLU in sales entry will

cause an error.

TEC MA-1350-1 Series Programming Manual

Other manuals for TEC MA-1350-1 Series