What to do if my tecan sunrise shows an 'Out of memory in module' error?
If your Tecan Laboratory Equipment displays an 'Out of memory in module' error, it's likely due to an internal firmware error. Try turning the instrument off and then on again. If the error persists, contact your local service engineer.
Why does my tecan sunrise Laboratory Equipment say 'Not implemented'?
If your Tecan Laboratory Equipment displays a 'Not implemented' error, this is due to an internal firmware error. You should switch the instrument off and then on again. If the error continues after restarting, contact your local service engineer.
What to do if the Tecan Laboratory Equipment displays 'Timer event not active'?
If your Tecan Laboratory Equipment shows a 'Timer event not active' error, it indicates an internal firmware error. To resolve this, switch the instrument off and then on again. If the problem continues, it is recommended to contact your local service engineer.
General| Detection Mode | Absorbance |
|---|---|
| Plate Formats | 96-well plates |
| Light Source | Xenon flash lamp |
| Measurement Range | 0 - 4 OD |
| Shaking | Linear shaking |
| Interface | RS-232 |
| Measurement Modes | Endpoint, Kinetic |
| Wavelength Selection | Filters |
To Next Page
