Tech Controllers i-2 User Manual

16
3. FITTER’S MENU
Fitter’s menu is intended to be used by a qualified person in order to configure additional functions of the
controller. Below you can find a simplified block diagram of Fitter’s menu.
3.1. BLOCK DIAGRAM OF FITTER’S MENU
NOTE
Depending on the number of valves selected, additional options may appear in the menu: ‘Valve 2’, ‘Additional
valve 1’, ‘Additional valve 2’, with the same submenu as for ‘Valve 1’ (described in section 7).
Fitter’s menu
TECH RS regulator
ON
OFF
Number of valves
Number of built-in
valves
Number of additional
valves
Valve 1
Additional contacts
Ethernet module
External sensor
calibration
Factory settings

Tech Controllers i-2 Specifications

General

Brand	Tech Controllers
Model	i-2
Category	Controller
Language	English