3. Change the date, the hour, and the minute as describe in Step 2 above, using the “ ”
key to change and the
key to confirm the entries.
4. “0” will reappear, as the Blood Pressure Monitor is ready for measurement again.
Press the
key
Blinking month
Increasing month
Confirm the entry
Troubleshooting
If any abnormality will arise during use, please check the following points.
Symptoms Check Point Correction
Have the batteries run down?
Replace them with two new alkaline
batteries.
No display when the
START key is pressed
Have the batteries polarities
been positioned incorrectly?
Re-insert the batteries in the correct
positions.
Is the cuff placed correctly?
Wrap the cuff properly so that it is
positioned correctly.
Did you talk or move during
measurement?
EE symbol shown on
display or the blood
pressure value is
displayed excessively low
(high)
Did you shake the wrist with the
cuff on?
Measure again quietly. Keep wrist
steady during measurement.
Note: If the unit still does not work, return it to your dealer. Under no circumstance should you
disassemble or repair the unit by yourself.
Cautionary Notes
1. The unit contains high-precision components. Therefore, avoid extreme temperatures,
humidity, and direct sunlight. Avoid dropping or strongly shocking the main unit, and protect it
from dust.
2. Clean the blood pressure monitor body and the cuff carefully with a slightly damp, soft cloth.
Do not bend the pre-formed cuff inside out. Do not wash the cuff or use chemical cleaner on it.
Never use thinner, alcohol or petrol (gasoline) as cleaner on it.
3. Leaky batteries can damage the unit. Remove the batteries when the unit is not used for a
long time.
4. Do not press the
key when the cuff is not placed around the wrist.
5. The unit should not be operated by children to avoid hazardous situations.
6. If the unit is stored near freezing, allow it to acclimate at room temperature before use.
To Next Page
Loading...
Need help?
General
