15
Recording onto a USB flash drive
This equipment has the capacity to encode your traditional music media
(vinyl records, cassette tapes, Bluetooth audio, radio or CDs) into digital
format and record it onto a USB device as MP3 file(s).
⚫ Insert a storage device (USB-Stick) into the USB slot.
⚫ Get your traditional music media ready for playback: Either place a
record on the turntable, insert a cassette tape into the cassette slot, insert
a CD into a CD player or connect a different recording medium to the AUX
IN socket.
⚫ Set the function switch to the appropriate function: PHONO, CD, TAPE,
RADIO (FM/DAB), BT or AUX.
⚫ Press the RECORD button (14) to start the recording.
⚫ Press the STOP button to stop recording. The music track(s) will be
saved directly on the USB flash drive as MP3 file(s).
NOTE: If you are recording via Cassette, make sure an AUX IN cable is
not connected to AUX socket. ⚫ Mute the volume will also mute the record.
Volume decrease or increase has no impact to the record. ⚫ The recording
speed is 1:1. Recording will take as long as playing the record, cassette
tape or CD. ⚫ The recording format is preset at MP3 bit rate 128 kbps.
DELETE FROM USB
To delete a file from your media storage device, in stop mode, first select
the track by using the ◀◀ or ▶▶ buttons. You can also delete a track while
it is being played in playback mode. Press and hold the REC/DEL button
until the DEL indicator flashes on the display. You can choose between
delete one file, folder or all by pressing ◀◀ or ▶▶. Then press the
REC/DEL button again and the file will be deleted.
Bluetooth mode
Bluetooth playing
⚫ Select the source switch to “Bluetooth”. Then you should turn on your
phone or other media device and start the Bluetooth searching function,
receive carrier will receive the Bluetooth identification number for:
“Technaxx TX-137”, when your Bluetooth device is connected, the
speaker will beep.
Select the ▶▶, ◀◀, ▶‖ or ■ buttons, which can make you pause/play,
interrupt or stop the songs. To quit the function, change the source or press
the POWER to standby the device.
To Next Page
Loading...
Need help?
General
