8
First start
Carefully read the manual. Plug the power adapter into a 100-240V AC
outlet and the other end into the TX-137 (30). Be reminded: “Non-
connected devices always work faulty”. Power on the device by pressing
the Power button (1). After that start the mode you like to playback. Use
the turning knob to change the source (1).
Setting the display system
1. Press the power/source (1) button to power the device on. The display
will light up.
2. Hold and Press the MENU (13) button. Then press the previous or next
button (3/5) until select the “SYSTEM”. Press previous or next button again
to select time set up / alarms / sleep / equalizer / language / back light
/ factory reset / SW version.
3. Then selecting time set up by press ENTER (4), press the previous or
next button to select set clock/ set date/ set auto update/set 12or 24 hours.
Then press the ENTER button to confirm.
4. If setting clock or date, keep press the previous or next button to set
hour & minutes, then press the ENTER button to confirm.
5. If setting the Auto-Updating, follow the above procedure 2-3 and select
auto update. Then press the previous or next button to select options like
radio.
6. If setting the alarms, press the previous or next button to select alarms
set up then select alarms on or off and alarms 1 or 2. Setting alarms time
after select alarms mode (Detail / DAB / FM / buzzer) and setting alarms
volume.
7. If setting the sleep, press the previous or next button to select sleep and
press ENTER button to confirm. Selecting sleep timer 15/30/45/60/90
minute and sleep off.
8. If setting equalizer, press the previous or next button to select equalizer
and press ENTER button to confirm, selecting EQ flat / rock / classic / jazz
/ pop / bass / custom (selecting custom and press the previous or next
button to select bass or treble audio effect).
9. If setting the back light, press the previous or next button to select back
light and press the ENTER button to confirm, selecting backlight level
(high/low/medium) and backlight time (10/20/30/45/60/90/120/180) Sec.
10. If setting the factory reset, press the previous or next button to select
factory reset and press ENTER button to confirm, select yes or no, delete
To Next Page
Loading...
Need help?
General
