1000BASE-T1 MediaConverter EMC User Manual
2.1.2 Optical Interface on the backside
The optical interface is a serial terminal connection. For using this, a special USB
Adapter is required. For detailed Information see CHAPTER 0.
Figure 2-3: USB-Opto-Adapter
Plug in the optical cable on both sides’ crossover. RX – TX
Open a Terminal program (e.g. TeraTerm) at your PC and open the USB Device
as serial connection.
Speed settings: 14.400 kbaud/s and 8N1.
Status information is displayed. The error counter can be reset by pressing
“Space” key
To Next Page
Loading...
