CBR CGA4131COM- User Guide
18 of 61
2.2 Power on the Gateway
Procedure
Proceed as follows:
1. Use the power cord that is included with your Gateway.
2. Connect the small end of the power cord to the Power port on the back of the Gateway.
3. Plug the other end of the power cord into an electrical outlet.
4. Wait at least two minutes to allow the Gateway to complete the startup phase.
2.3 Connect your wired devices
Requirements
• Both your network device (for example, a computer, a point of sale terminal, etc.) and Gateway must
have a free Ethernet port.
• Your network device must be configured to obtain an IP address automatically. This is the default setting.
All Ethernet ports on the Gateway are Gigabit Ethernet ports and have a maximum speed of 1 Gbps
(Gigabit per second).
Procedure
Proceed as follows:
1. It is recommended to use Category 5e or Category 6 Ethernet cables with the Gateway
2. Plug one end of the Ethernet cable into one of the RJ-45 Ethernet ports on the back of the Gateway:
To Next Page
Loading...
