CBR CGA4131COM- User Guide
21 of 61
Troubleshooting
If you are having trouble connecting your wireless client via WPS, this may be caused by one of the following
reasons:
• WPS cannot be correctly executed:
Configure your wireless manually. For more information, see “2.4.2 How to manually connect your
wireless client”.
• Your wireless client is out of range:
If possible, move your wireless client closer to your Gateway or use a wireless repeater to extend the
range of your wireless network.
2.4.2 How to manually connect your wireless client
Requirements
• Your network device must be equipped with a WiFi Certified wireless client.
• Your network device must be configured to obtain an IP address automatically. This is the default setting.
Procedure
If you want to connect a computer using the wireless network, configure the wireless client on your computer with
the wireless settings printed on the Gateway's back panel label.
Network Name 1 (SSID): CBCI-XXXX
Network Name 2 (SSID): CBCI-XXXX
Password: ***************
***************
The Gateway’s back panel contains two items needed to establish a Wi-Fi connection:
• Network Name (SSID) is the default network name. This network name is used by both the
2.4GHz and 5 GHz access points and is in the following format:
CBCI-XXXX (where X is last 4 octets of CM MAC).
• Password (Key) is the default password used for both the 2.4 GHz and 5 GHz access points
To Next Page
Loading...
