Page 1 / 85
Safety Instructions
Using equipment safely
Your Cable Modem Gateway product has been manufactured to meet European and local safety standards,
but you must take care if you want it to perform properly and safely.
It is important that you read this booklet completely, especially the safety instructions below.
Equipment connected to the protective earth of the building installation through the mains connection or
through other equipment with a connection to protective earth and to a cable distribution system using
coaxial cable, may in some circumstances create fire hazard. Connection to a cable distribution system has
therefore to be provided through a device providing electrical isolation below a certain frequency range
(galvanic isolator, see EN 60728-11).
If you have any doubts about the installation, operation or safety of the product, please contact your supplier.
To avoid the risk of electric shock
Disconnect the Cable Modem Gateway product from the mains supply before you connect it to (or
disconnect it from) any other equipments. Remember that contact with Mains can be lethal or causes
severe electric shock.
Never remove the product cover. Should the product fail, contact the Customer Service to arrange
repair or service.
Never allow anyone to push anything into holes, slots or any other opening in the case
Do not block the ventilation slots; never stand it on soft furnishings or carpets
Do not put anything on it which might spill or drip into it (e.g. Lighted candles or containers of liquids).
Do not expose it to dripping or splashing. If an object or liquid enters inside the Cable Modem, unplug
it immediately and contact the Customer Service.
Do not store the Cable Modem Gateway product in excessively hot, cold or damp conditions. It is
intended to operate at an ambient temperature of less than 35 degrees Celsius and a maximum humidity
level of 70%. In case of a storm, it is recommended that you unplug the product from the mains and
from the PC set or other equipment.
Leave the mains socket accessible so that you can unplug the set quickly
Telephone jacks Line 1 and Line 2 must not be connected to outside wiring.
Connecting to the mains supply
This appliance is designed to operate in the rated voltage 110 ~ 240 VAC.
If you are in any doubt about the mains lead, the plug or connection, please consult the Customer
Service.
Only the power adapter supplied with the product has to be used.
Ensuring optimum performance
Leave 7cm to 10cm around the appliance to ensure that proper ventilation gets to it.
Do not store your appliance on its side (if not allowed)
To clean the appliance, use a dry, clean soft cloth with no cleaning solvent or abrasive products. Clean
the ventilation openings regularly.
To Next Page
Need help?
General
