Technicolor TG213 - Configuring Windows Vista; Configuring Windows 7

Configure the Computer
Power Wall Plug Repeater 38
Windows Vista
If you are using Windows

Vista, follow the instructions below to configure your
computer.
1. Click Start > Control Panel > Network and
Internet Connections > Network
Connections.
2. Right-click Local Area Connection, then click
Properties.
3. On the General tab, make sure that
Internet
Protocol (TCP/IP)
is checked. If not, check it
to enable the
Properties
button.
4. Select Internet Protocol (TCP/IP), and then
click Properties.
5. Select Obtain an IP Address automatically
and Obtain DNS server address
automatically.
6. Click
OK
.
General Page
Windows 7
If you are using Windows

7, follow the instructions below to configure your
computer.
1. Click Start > Control Panel > Network &
Sharing Center.
2. Click Local Area Connection.
3. Click Properties.
4. On the network components list, make sure
that
Internet Protocol (TCP/IP)
is checked. If
not, check it to enable the
Properties
button.
5. Select Internet Protocol (TCP/IP), and then
click Properties.
6. On the General tab, select Obtain an IP
Address automatically and Obtain DNS
server address automatically.
7. Click
OK
.
General Page