EasyManuals Logo

Technicolor TG582n User Manual

Technicolor TG582n
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
21
3 MANUAL INSTALLATION
DMS-CTC-20101206-0009 v1.0
3.3.2 Setting up a Wired Connection
Requirements
Both your network device (for example, a computer, a gaming console,...) and Technicolor Gateway must have a free
Ethernet port.
Your network device must be configured to obtain an IP address automatically. This is the default setting.
Ethernet cable
In your package, you will find a cable with yellow connectors. This is the Ethernet cable.
Procedure
Proceed as follows:
1 Connect one end of the Ethernet cable to one of the yellow Ethernet ports of your Technicolor Gateway:
2 Connect the other end of the Ethernet cable to your network device.
3 Your network device is now connected to your network. No additional configuration is needed unless specified by your
service provider.
The Technicolor Gateway does not support Power over Ethernet (PoE). All network devices that are connected
to the Technicolor Gateway must be powered by their own power source.

Table of Contents

Other manuals for Technicolor TG582n

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Technicolor TG582n and is the answer not in the manual?

Technicolor TG582n Specifications

General IconGeneral
TypeADSL Modem Router
Wi-Fi Standards802.11b/g/n
AntennaInternal
SecurityWEP, WPA, WPA2
VoIPNo
Ethernet Ports4
USB Ports1 USB 2.0 port
ADSL StandardsADSL2, ADSL2+

Related product manuals