22
3 MANUAL INSTAL
LATION
DMS-CTC-20101206-0017 v1.0
3.2 Powering on the Technicolor Gateway
Procedure
Proceed as follows:
1 Connect the power cord to the power port of the Technicolor Gateway.
2 Plug the other end of the power cord into an electrical outlet.
3 The Technicolor Gateway automatically starts up.
For more information about how to powering on/off the Technicolor Gateway, see “Power switch” on page 7.
4 Wait at least two minutes to allow the Technicolor Gateway to complete the start up phase.
To Next Page
Loading...
