99
10 INTERNET SECURITY
DMS-CTC-20110713-0016 v2.0
Option 1: content-based filter (combined with the address-based filter)
If you want to use the content-based filtering:
1 Browse to the MediaAccess Gateway GUI.
For more information, see “Accessing the MediaAccess Gateway GUI” on page 37.
2 On the Toolbox menu, click Parental Control.
3 On the Navigation bar, click Configure.
4 Make sure that the Use Content-Based Filter check box is selected.
5 Configure the content-based filter. For more information, see “10.1.1 Configuring Content-based Filtering” on page 100.
6 If you want to make exceptions for specific web sites, add the necessary rules in the address-based filter. For more
information, see “10.1.2 Adding Rules for Address-Based Filtering” on page 101.
Option 2: address-based filter only
Take this option if content filtering is not available on your MediaAccess Gateway or you don’t want to use it.
To configure address-based filtering:
1 Browse to the MediaAccess Gateway GUI.
For more information, see “Accessing the MediaAccess Gateway GUI” on page 37.
2 On the Toolbox menu, click Parental Control.
3 On the Navigation bar, click Configure.
4 Make sure that the Use Address-Based Filter check box is selected.
5 In the Action for Unknown Sites, select:
Allow as the default rule if you want to allow access to all web sites and manually specify which web sites may not be
accessed.
Block as the default rule if you want to deny access to all web sites and manually specify a number of web sites that
may be accessed.
6 Click Apply.
7 If you want to make exceptions for specific web sites, add the necessary rules in the address-based filter.
For more information, see “10.1.2 Adding Rules for Address-Based Filtering” on page 101.
To Next Page
Loading...
Need help?
General
