Preparation
12
Charging
The chargeable battery (installed in the unit) is not charged initially. Charge the battery before using the unit.
• Proper charging is not possible if there is dust or droplets of water on the terminal sections of the earphones or
charging cradle. Remove the dust or water droplets before charging.
Note
• Charge in a room temperature between 10 oC and 35 oC (50 oF to 95 oF).
• It is not possible to turn the power on or connect to Bluetooth
®
devices during charging.
When the earphones have not been put into the charging cradle, the charging cradle itself is charged.
1
Use the USB charging cord (supplied) (b) to connect the charging cradle to a
computer (a).
• Charging of the charging cradle starts. The charging cradle LEDs light or blink (white) while the charging
cradle is charging. Charging is complete when they turn off.
• Check the direction of the USB charging cord terminals and plug in/out straight holding onto the plug. (It may
result in malfunction by the deforming of the terminal if it is plugged in obliquely or in wrong direction.)
2
Put the earphones into the charging cradle.
• Confirm the L side and R side of the earphones, and match the positions of the charging terminals on the
earphones with the terminal sections in the charging cradle. (Charging of the earphones will not start if the
positions do not match.)
• The way the earphone LEDs light when you put the earphones into the charging cradle depends on the usage
status.
Using the USB charging cord (supplied) to charge the earphones and the charging cradle
Usage status Earphone LED lighting/blinking patterns
Charging for the first time (after
purchase)
The earphone LEDs light (red) about 5 seconds after you put the
earphones into the charging cradle.
Charging any time after the first time
(When there is still battery charge)
When you put the earphones into the charging cradle, the
earphone LEDs light (red) about 3 seconds, then turn off. After
about 5 seconds, the earphone LEDs light (red) again.
• If the earphone LEDs do not light (red) again, the earphones are
fully charged.
When the batteries are depleted (When
there is no battery charge at all)
The earphone LEDs light (red) about 5 seconds after you put the
earphones into the charging cradle.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
