44
Manually tuning
If “Scan Failed” is displayed after “DAB/DAB+” is
selected or after an auto scan, use this function to
scan a frequency block.
■
Preparation
• Note down a frequency block that can be received
in your region (e.g., 12B 225.648 MHz).
• Adjust the position of the DAB antenna.
1 Press [MENU].
2 Press [
], [ ] repeatedly to select
“Manual Scan” and then press [OK].
3 Press [
], [ ] to select the frequency
block that is receivable in your region
and then press [OK].
• If “Scan Failed” is still displayed, repeat steps 1 to
3 until a station is stored. If the situation does not
improve, use an outdoor DAB antenna or consult
your dealer.
Checking the DAB/DAB+ signal
reception quality
1 Press [MENU].
2 Press [
], [ ] repeatedly to select
“Signal Quality” and then press [OK].
• The current frequency block is displayed and
then the reception quality is indicated.
• Reception quality: 0 (poor) – 8 (excellent)
3 If the signal reception quality is poor,
move the antenna to a position where
the reception quality improves.
4 (To continue checking the quality of
other frequency blocks:)
Press [
], [ ] again and select the
desired frequency.
5 Press [OK] to exit.
• If the antenna has been adjusted, perform the
auto scanning and update the station memory.
To Next Page
Loading...
