Technics RS-B11W

TAPE 2A ****************** B TAPE I
DUBBING RECORDING
p!ayback
record/p!ayback
oRelease(.-. )to the '^out" position.
$Select the dubbing tape speed.
"$no.mal" ... for operation at the ord/na^ tape speed
".high.'... for operation at double speed
(Tfie dubbing tape speed Indicator will illuminate.)
0Press to the on"position($—$).
(The dubbing/mixing indicator will illuminate.)
oInsert the recorded tape to be played back.
.Press toon”(
)
0Insert the tape to be used
for recording.
.Press.
ΦPress.
(The recording indi-
ca t o r wil l il lu mi n a t e,
t h e u n i t i s n o w i n
the recording stand-
by mode.)
.Press.
.Press.
(The unit is now
playback stand-
by mode.)
$
Ỉ
I
8
Ĩ
Cí
t
D
->
'
>
'
1
8
E
/.$
$:!
i'il®./ --@ E#
Λ
F ******************* 3 ****************** G$:/7
#
I
I
C
; H
I2
J!
K9
C
Üİ
6
—nf:
6
<
I
Set to the minimum
(0) position.
Φ Either of 2speeds can be used for edit-recording. It the high ($)
tape speed is selected, edit-recording from tape to tape Is
possible in one-tialf the time as at the normal (i) speed,
the “normal" position should be used if you want to enjoy
listening to tfie edit-recording as it is being made. (Set the tape
speed to
Press the pause button for tape deck 1and for tape deck 2
at the same time.
(Tape deck 1playback and tape deck 2recording will then
begin.)
normal.)
Note:
When dubbing recording atape recorded Dolby NR. there may be
some change in the tone guality and amount of noise on ttie tape,
there may also be some changes in the tone guality and amount of
noise on the during tiigh speed dubbing recording.
■Line input
If there is no mlcroptione connected to the center microphone jack,
it is possible to make amixing recording, or to enjoy mixed playback,
of playback sound from tape deck 1and aline input source (such as
atuner, record player, etc.).
$Use the input level control to adjust the level of the line input.
_8_