Technics RS-BX606

Ref. No.
3
Procedure
Removal of the front panel ass’y
2. Remove the 2 connectors (CP1, CP2).
3. Remove the 1 flat cable (CN60).
Front panel assy
4. Remove the front panel ass’y in the direction of
arrow.
Procedure
-1-3--4
¢ Pull out the flat cable while
pressing the connector.
Connector
FL drive PC.B.
Rec level knob
3. Remove the 2 flat cables (CN40, J971).
4. Remove the 1 screw (@).
1. Pull out the rec level knob. 5. Release the 2 claws.
2. Remove the nut. 6. Remove the FL drive P.C.B. in the direction of
arrow.
Removal of the operation P.C.B.
pea
Removal
of
the
rec
level
P.C.B.
sala
Procedure
FL drive PCB.
1. Pull out the 2 knobs.
2. Remove the 7 screws (@~@).
3. Release the 9 claws.
* Remove the rec level P.C.B. in the direction of
arrow.