Technics RS-CH7 - Page 4

RS-CH7
m@ DISASSEMBLY INSTRUCTIONS
“ATTENTION SERVICER”
Some chassis components may have sharp edges. Be careful when disassembling and servicing.
Ret Ref. No.
1
Procedure
1
| Removal of the Cabinet
Remove
6
screws
(Q@~@).
Ref. No.
2
Removal of the Mechanism Control
P.c.B.
Removal
of
the
Flat
Cable
(J951, J971) (CN4, CN6)
Procedure
4
Push
1. Remove the screw (@).
2. Remove 2 claw in the direction of arrow @ and then remove the
holder.
3. Remove the mechanism control P.C.B. in the direction of arrow
4. Remove 5 flat cable (CN4, CN6, CNQ, J951, J971).
5. Remove the connector (CN7).
Removal of the Main P.C.B.
Procedure
152-53
CP2
Main P.C.B.
CPI
1.
Remove
2
connector
(CP1,
CP2).
2.
Remove
5
screws
(@~@).