Technics RS-D200

©
Dolby
NR
Button
[Dolby
NR
(M
out-=
in)]
Press
for
a
Dolby
noise-reduction
recording
(or
playback).
@
Input Selector [input select ( line+ = mic)}
Press to select the recording source.
EE line...Recording from LINE IN Jacks.
m mic...Recording from microphone.
Microphones jacks [mic (left-right)]
When a microphone is connected to the Microphone Jack,
recording can be made through the microphone.
@Dolby
noise
reduction
system
manufactured
under
license
from
Dolby
Laboratories
Licensing
Corporation.
‘Dolby’
and
the
double-D
symbol
are
trademarks
of
Dolby
Laboratories
Licensing
Corporation.
x
{A
1
9
z
ut
@ Notes
1. If possible, avoid using 120-minute tape.
Because this tape is very thin, it might stretch during use,
become tangled with rotating parts in this unit, and/or tape
movement might not be stable.
2. Tape looseness
If the tape is loose in the cassette, it may result in scratches
on the tape or even tape breakage.
3. If tape is not wound evenly, or is wound too tightly.
Fast forward and then rewind the tape on time.
4. Do not pull the tape out from the cassette; don’t touch the
tape.
When not using a cassette, be sure to store it its case.
@ Accidental-erase-prevention tabs
Each tape cassette has two (for sides 1 and 2) taps which, when
broken out ance recording on the tape.
- Break out the tab. ‘
a fecording cant pe ade.)
“fab {or side 1
yeh for side 2
- Tab
: “Use a . screwdriver or
. similar tool.
@ To re-record on the tape
@ Avoid these places...
e@Where the temperature is high (35°C or higher) or where the
humidity is high (80% or higher).
eWhere there is a strong magnetic field (near a speaker, on top
of a TV, etc.).
ein direct sunlight.