Technics RS-TR252

recording
During recording, press 1 Press I] PAUSE during recor-
STOP on Deck 1. ding.
(Deck 1 will stop, and Deck 2 will (Deck 2, which was recording, will
record a 4-second silent interval and enter the pause mode, and Deck 1 will
then enter the recording standby continue playback.)
mode.)
Operate Deck 1 to find the track you
wish to record.
It is also possible to change the playback tape at this
time.
[When Deck 1 reaches a part you wish
to record]
Press either <q PLAY or >
PLAY, corresponding to the
side of the tape side in-
ec ee ira dicator which is tit.
syncuro staat Progs SYNCHRO START. (Recording will resume.)
rs (Recording will resume.)
neat pe iy on NHN re G fad 3 =
[> atta
Tape side indicator (<] or >)
To erase recorded sound
When new recordings are made on a pre-recorded tape, ail 4 Set the REC LEVEL control to “0”.
sounds recorded on that portion of the tape are automatically
erased. To erase a tape without making a new recording, follow & Press @ REC.
the steps below. (The unit will be in the recording standby-mode.)
1 Press EJECT on Deck 2 and then insert the record: 6 Press <{ PLAY or B® PLAY to begin erasing the
ed cassette tape. tape.
> PLAY : Forward side
D Press either DOLBY NR B or C so that the Dolby “@ PLAY : Reverse side
NR indicators are off.
8 Press ——, GD or © to select the desired To erase both sides of the tape, be sure to press the B» PLAY
reverse mode. button.
=: To erase one side of the tape.
Cz), GSD: To erase both sides of the tape.
13