Technics RS-TR252

Either normai, CrO,. or metal type cassettes can be used.
Use Deck 2 to record the sound being played back on Deck 1.
412 31
Preparation
Wind the tape past the leader tape section so that recording can
begin straight away.
Press EJECT on both decks,
and then insert the cassette
tapes.
Deck 1: For playback
Deck 2: For recording
"REVERSENODE Press <>, Cx) or OO to
= fo]
© © 0 select the desired reverse
®» mode.
Reverse-mode
indicator
({—,
C=*>
or
GD)
==: Only one side of the tape will be
recorded, and then operation
will automatically stop.
C2): Both sides of the tape (first the
forward side and then the
reverse side) will be recorded,
and then operation — will
automatically stop.
if the recording tape is longer
than the playback tape, the
playback tape will be played
repeatedly as many as eight
times until the recording tape is
finished.
XD: Both sides of the tape (first the
forward side and then the
reverse side) will be recorded
once, and then operation will
automatically stop.
To record on only one side of the tape, set the tape side in-
dicators (<] or [>) on Deck 1 and Deck 2 in accordance with the
tape sides to be played back and recorded.
To record on both sides of the tape, set the tape side indicators
on both Deck 4 and Deck 2 to the forward side (>).
12
xispeco x2sPeeo Press either x1 SPEED or
x2 SPEED to select the
recording speed.
Tape-speed indicator (x 1 or x2)
x1: Normal speed
x 2: Double speed
“" snwoster” Press SYNCHRO START.
oe (The recording will begin.)
To stop recording
Press Mi STOP on Deck 2.
®§
(On Deck 2)
in order to avoid operation errors later, be sure to switch OFF
the SPEED buttons (the x1" and 2" indicators will go
out) after the tape-to-tape recording has finished.
For your reference:
©The recording level and the Dolby effect will be recorded as
they are on the tape being played back,
© Because the signal being recorded from Deck 1 onto Deck 2
does not pass through the amplifier, it is possible to change the
setting of the amplifier's input selector during recording in
order to listen to some other sound source.
When recording with the recording speed set to double speed,
noise interference may be recorded onto the tape if there is a
television set nearby, so make the recording In a location
separated from the television set or switch off the television set
during recording.