Technics RS-TR474 Operating Instructions

12
fEecur aig ETO aT CITELY:
Either normal, CrO, or metal type cassettes can be used.
This unlit Is equipped with an ATC function (refer to page 14)
which automatically sets the optimum recording conditions to
match the characteristics of the tape being used. {It is recom-
mended that you use this function when recording.
|
1. Switch on the power.
2. Load a tape which has been advanced to the end of the leader
tape (the transparent part at both ends of the tape) into Deck
2.
Press DOLBY NR to select
[z/ the desired nolse-reduction
system. (Refer to the opposite
page.)
fann = nan
ve Att iuiiitu
\w mn w]e 2 wo ee
i =|
Each time the button is pressed, the in-
dicator will change in the order:
(B] ~ {Cj + off.
“reverse “Press REVERSE MODE to
MODE
select the desired reverse
Crd, mode.
faAn = mn
ut i
Ut us rus LI
\-10 eos} -3 mote te ‘S
bs
Each time the button Is pressed, the In-
dicator will change in the order:
ae eH mee.
| See eer ee |
== =: Only one side will ba recorded,
and then operation will automaticaily
stop.
7D. &x> : Both sides (the forward
side first, and then the reverse side)
will be recorded, and then operation
will automatically stop.
ty
Press ATC.
Setting of the ATC (refer to page 14)
will commence. and wil! be compieted
after approximately one minute.
When the settings are complete, the
tape will be returned to the position
from which the ATC function began,
and then the unit will enter the stop
mode
/ 1
wn = mao
weil os eeu du
\40 0 -e 4-3 ooo] 4s
l |
indicates that ATC has been set.
REC Press REC @.
(The unit wilt be in the racording stand-
by mode.)
tumirates:
non = on ool
UU we we Ue |
wo a oe ee PLAY
=a
Play the source in order to
adjust the recording sound.
only
saance If necessary, adjust the
Co) BALANCE control to adjust
the balance.
(Refer to the oppasite page.)
(fhe control should normality be set to
the center position.)
TR
Gl
LEFT

Technics RS-TR474 Specifications

General

Track System	4-track, 2-channel stereo
Tape Speed	4.8 cm/s
Frequency Response	20Hz to 17kHz (Metal tape)
Type	Cassette Deck
Heads	1 x Record/Playback, 1 x Erase
Motor	DC motor
Output	400mV (Line)
Dimensions	430 x 125 x 290mm
Power Supply	220-240V AC, 50Hz