Technics RS-TR474 Operating Instructions

Both sides of the tape in Deck 1 will be played, followed by beth
sides of the tape In Deck 2. (Repeated up to eight times.)
Preparation
Load the tapes to be played into Deck 1 and Deck 2.
Note that for series playback it is not possible to select different
types of Dolby NR for Deck 1 and Deck 2. It is recommended that
you use two tapes which were recorded using the same type of
Dolby NR (or both recorded without Dolby NR).
SpoLYNR Press DOLBY NR to select
the appropriate nolse-reduc-
tlon system.
2 everee Press REVERSE MODE to
select the “<x>” mode.
cA
Press ® on Deck 1.
aie | (Series playback will begin from the
forward side of the tape in Deck 1.)
For your reference:
It Is also possible to begin series playback from the reverse side
of the tape in Deck 1 or from Deck 2. (Refer to the tape travel
table on page 8.)
To temprarily stop playback
(Deck 2 only)
Press OI.
Press once again to resume playback
To stop playback
Press Hi for the deck which is play-
ing.
The finear counter indicates the amount of tape travel as the
approximate amount of elapsed time.
Deck 1, Deck 2)
Linear counter Linear ccourter
Minutes Minutes
Seconds Seconds
COUNTER 1 COUNTER 2
RESET RESET
Ce © arr ere mn
To reset the linear counter
counteRt Press COUNTER RESET.
RESET ; :
The linear counter indication will return to
Ro “00.00”.
For your reference:
When the tape is travelling in the reverse direction, the value
displayed on the linear courter will count down. 3
After "00.00" is reached, the value wil! then start to become
greater, but with a minus sign displayed (example: “—00.08").
The linear counte: is not a digital clock. The difference between
the actual recording and playback time and the counter display
may be anything up to several minutes.

Technics RS-TR474 Specifications

General

Track System	4-track, 2-channel stereo
Tape Speed	4.8 cm/s
Frequency Response	20Hz to 17kHz (Metal tape)
Type	Cassette Deck
Heads	1 x Record/Playback, 1 x Erase
Motor	DC motor
Output	400mV (Line)
Dimensions	430 x 125 x 290mm
Power Supply	220-240V AC, 50Hz